Laying out and storing the cable between runs
Most cable trouble starts after the swim, when the robot's put away. A few habits there save you a knot next week.
After the run
Beatbot says to take the cable out of the water slowly and let it drain.1
Then comes the part people get wrong. Don't wrap the cable tightly around the caddy, which is the wheeled cart some robots come with. Beatbot says to store it in large, loose loops or in a figure-eight shape. Tight wrapping encourages cable memory, the curl the cable keeps from storage.1
Pentair's Prowler 710 guide says to leave the cleaner on all four wheels in a dry, shaded area, together with its power supply and a properly coiled floating cable.2
Out of the pool, not in it
Pentair says not to leave the cleaner in the pool when it's not in use.2
There's a safety reason too. The same page says not to allow swimmers in the pool while the cleaner is in there. The cable can trip or entangle swimmers, which could result in drowning.2
Follow your own manual's rule on swimmers.
Keep it out of the sun
Beatbot advises against leaving the cable in direct sunlight for long periods when it's not in use. Heat and UV exposure can make the outer jacket harder and more brittle over time.1
Its FAQ sums up the storage rule: dry, shaded, and in large loose loops.1
That may sound like it clashes with the advice on the untangling page, which lays the cable in the sun for a few hours. It doesn't. Sun for a set time on a day you're straightening it is one thing. Leaving it there for good is another.
Before the next run
Beatbot says that before each cleaning cycle you should unwind the cable completely and place it loosely along the pool edge.1
Look it over as you go. Pentair's guide tells you to make sure the floating cable isn't tangled or kinked before the robot goes in.3
At the end of the season
Pentair says to clean the filter bag, make sure there's no water in the cleaner, and completely untangle and then properly coil the floating cable. It adds that the cleaner and power supply should be stored in a dry, protected area away from freezing temperatures.2
Those are one model's steps. Your manual may add its own, so read the storage section for your robot.
A simple routine
- Lift the cable out slowly and let it drain.
- Coil in big, loose loops, or a figure-eight.
- Keep it dry and out of long sun.
- Unwind it fully next time and check for kinks.
If the cable still kinks even with all this, the length may be wrong for your pool. See cable length and pool size.