Cable length and pool size: what makers say
Cable length is one of the few tangle causes you can fix without buying anything. Too long and the extra floats about. Too short and the robot can't reach.
What too long and too short do
A cable that's much longer than the pool needs leaves spare length floating. Beatbot says that extra length can interfere with the robot's navigation.1
A cable that's too short does the opposite. Beatbot says it pulls the robot backwards and limits its cleaning coverage.1
Which is worse? Neither page ranks them. Both are reasons to match the cable to the pool.
| Cable is | What Beatbot says happens |
|---|---|
| Too long | Excess floats in the water and the extra length can interfere with navigation1 |
| Too short | It pulls the robot backwards and limits cleaning coverage1 |
A rule of thumb from one maker
Beatbot gives a simple rule: the useful cable length should cover the diagonal of the pool plus about one metre of extra margin. Its example is a rectangular pool measuring 8 by 4 metres. The diagonal is around 9 metres, so a cable of around 10 metres is often enough.1
That page uses metric units. If your pool is measured in feet, convert before you compare, and treat this as a starting point. Your manual's own figure for your model wins.
Where the cable and power supply go
Makers also say where to start from. Pentair's Prowler 710 guide says that if the pool is elongated, such as rectangular or oval, you place the floating cable at the middle of the pool's length. That's to allow adequate cable length to reach the entire pool.2
SmartPool's Robo-Kleen manual puts it in terms of the power supply. Position it so the cleaner can reach all the walls. It also has to sit at least 10 feet back from the pool's edge.3
Pentair's guide adds a laying step. Uncoil the floating cable and spread it over the pool water surface.2
Those are two different makers describing one idea. Plan the cable's reach around the whole pool.
The distance rule has its own page: power supply placement.
When there's extra cable
Don't cut it. Beatbot says never to cut the cable yourself. Instead, keep the unused length outside the water with a suitable cable guide or loose cable tie, without tightening it too much.1
When the cable is short
Beatbot says to order a compatible replacement cable from the manufacturer. A different cable may not fit your robot.1
If your pool is bigger than your cable allows, ask the maker or an authorized dealer which cable your model takes. Don't join cables or add a cord to stretch the reach.
Once the length is right, the next job is keeping the cable from kinking between runs. That's covered in storing the cable.